Kitchen-sink-p-trap-height, the p-trap is an important component of sink plumbing that prevents toxic sewer gases from leaking into the home. the length of the tailpiece that connects the drain to the trap depends on a .... The drain line connects to the sink via a p-trap, a curved piece that prevents sewer gas from entering the bathroom, and a tailpiece, a straight piece that extends from the sink drain to the trap.in most cases, a standard tailpiece is the right length to reach from the sink to the trap, but in the case of a high drain line or an unusually low sink, the tailpiece can be cut to fit., is there a standard height off the floor for the cold/hot water supplies and the waste pipe or drain (the part the p trap goes into). i ripped out what was there before as the sink was a long distance from the waste pipe (terminoloy?) and the pitch was towards the sink and not the drain. i was thinking about 19" off the finished floor for the supplies and 12" for the drain?.
Re: sink drain rough in height crack he did not ask about a disposal, and i did'nt give him info for one sorry if i called you some one your not nervous . but my gut feeling tell me different. even your response back has the same vibe, and from new york area. if it is you gdavis62 its all good. you really kept the place hopping, the most common kitchen counter height is 36 inches, but it can vary from 30 to 45 inches. the standard kitchen sink is 8 inches deep, which means that the normal distance between a kitchen sink ....
I have p-trap entry in drain at 16" above the floor. however, vanity that i got has lower drawer which has top at about the same height. there is also about 4" clearance behind drawer. i was told that the only way to install p-trap would be to cut back of the drawer. so i wonder if it's really the case. can't drain entry be just raised with ..., install the garbage disposal onto the desired side of the sink first, since this takes up the most space. install a basket strainer onto the sink basin without the garbage disposal. this is also a good time to install any other under-sink components, such as a water filter or a hot water dispenser. continue to 5 of 6 below..
Complete your sink installation with this 1-1/2" x 1-1/2" p trap available in chrome, polished nickel or white.